Jet Pumps
Complete Dewatering’s High-Pressure Jet Pumps are used for water jetting wellpoint punches, casings, and self-jetting wellpoints into hard ground conditions.  They are also suited for temporary pumping under discharge pressure conditions or high discharge lifts.  CDPW can design and build high pressure pumps from 80 to 300 PSI, either diesel or electric powered.  CALL COMPLETE WITH YOUR SPECIFIC APPLICATION.
 
Standard model (2-1/2 JP) for hand jetting and small punches or casings.  High pressure model (3 JP) for large punches or casings or hose runs greater than 400’.
Download
Catalog Sheet
Download Cut Sheet 2.5" Jet Pump 
Download Cut Sheet 2.5" Jet Pump Economy
Download Cut Sheet 3" Jet Pump 
Features:
--Welded steel integral fuel tank sized for 24hr run time; clean out ports at all four corners
--Cast iron pump construction
--
Balanced impeller engine SAE mount or long coupled pump
--Hardened steel pump shaft
--High pressure brass gate valve on discharge
--Electric start / alternator
--
Extra-large hand primer
--Standard all models: Lockable fuel cap, Battery hold-down, Single point lifting bail, and Volute drain
--Murphy engine control panel
--Diesel engine (Tier 3 rebuilt or Tier 4 new) or Electric motor options available
  

  
Options:
--Engines: Deutz, John Deere, or Perkins (additional engines available upon request)
--“Whisper Pack” full or partial enclosures
--Trailer mounted: Highway wheels / tires, Torsion bar axle, DOT light kit, Highway fenders, Tow hitch, and Brake kit available
--Frame mounted hose carry racks and baskets
--Camlock suction and discharge fittings (please consult CDPW for additional fittings)
  
*Specify model JP = Jet Pump   
Applications:
--Jetting for wellpointing and bridge pilings
--Standby fire protection
--Irrigation for golf courses and agriculture
--Washing of crushed rock and industrial equipment